Clean The Screw Of A Twin-Screw Extruder-Disassemble

1. Manually add washing material from the discharge port until the color of the extruded material strip is the same as that of the washing material granules, stop feeding, empty the material, and stop the rotation of the twin-screw extruder screw;

2. Open the screw extruder die and start cleaning;

3. Rotate the screw of the twin-screw extruder and remove the orifice plate, discharge the residual washing material from the barrel, and clean the orifice plate;

4. Stop rotating and pull out the screw to observe if it has been cleaned thoroughly, and manually remove any remaining material from the screw. Reinstall the screw; Add new material to flush out the residual washing material in the barrel and stop the screw rotation;

5. Install the orifice plate and die head of the twin-screw extruder to complete the cleaning operation of the twin-screw extruder.